Results 1 to 20 of 28
-
07-18-2007, 06:34 AM #1
what should i run with a 100hp shot???
what should this run in the 1/4 mile?? 2002 Vette A4 trans 273 gears, only mods are a Vortex cold air intake, 100hp wet shot of nitrous no tune, Mickey Thompson et drag tires, are 11s possible?? What et and mph will i run?? D/a is going to be in the +2000 range saturday
-
07-18-2007, 07:08 AM #2
-
07-18-2007, 07:34 AM #3
before the nitrous, spinning the stock runcrap tires i ran a 12.79 at 111mph, now with drag tires and a 100hp shot what do you think i will run this weekend??
-
07-18-2007, 08:17 AM #4
-
07-18-2007, 08:59 AM #5
-
07-18-2007, 09:25 AM #6
heres a picture of the nitrous setup
-
07-18-2007, 11:52 AM #7
low 12s, MAYBE high 11s IMO.
Those gears are going to hurt your 60'....
GL man! Let us know how it goes!
-Eagle| '02 WS6 M6 | KOOKS/ORY | LC-1 | LOU'S SS | UMI SFCs | BMN LCAs & RELOC's | Hotchkis STB | HSW 150 shot | Lid | 42# Lucas | HPTuner Pro |
-
07-18-2007, 12:01 PM #8
Also, what RPM are you going to spray at? Going to hit it out of the hole in 1st?
Make sure you dont bog the motor down when you're @ low RPMs while spraying!!! I've seen a vette just like yours pop into flames (intake backfire) @ the track...
3000RPM should be pretty safe in 1st...
-
07-18-2007, 12:37 PM #9
-
07-18-2007, 12:45 PM #10
He had moved about 10ft off the line and it went BOOM. Not positive... but 2500 sounds pretty low to me on 273s...
Where's mrr when I need him...
-Eagle
-
07-18-2007, 01:18 PM #11
i always sprayed my truck at 2500rpm or less, went through 38 bottles with no problems using a 150hp shot, stock motor, over 5000 pounds
heres a video of me spraying at well under 3000rpm in my work truck, listen for when the nitrous comes on just after i launch.....copy and past the link for the video
http--home.comcast.net-~suzukirules-Hemi777_12.49.wmv
.
-
07-18-2007, 01:25 PM #12
Lookin good man! Although it has a cast alum intake... yes?
I'm just lookin out for ya! GL man...
-Eagle
-
07-18-2007, 01:31 PM #13
-
07-18-2007, 01:34 PM #14
-
07-18-2007, 01:36 PM #15
-
07-18-2007, 02:03 PM #16
Ah, and there it is!
-
07-18-2007, 02:14 PM #17
-
07-20-2007, 06:45 PM #18
get a stall convertor and youll be in the 11's with that IMO
-
07-21-2007, 12:53 PM #19
just got back from the track, first time out with the nitrous, after taking the advice from others i didn't spray to well after the 60ft mark because of my stock A4 trans and 273 gears so that only netted my 1.90 60ft times, time to get a converter so i can spray when launching for much better 60ft and 1/4 times, heres what the time slip shows i will post it tonight when i get it scanned.......with a 122.42mph what kind of times will i run with a 3600 converter?? i was only spraying a 100hp shot today, plans to spray a 200hp shot soon........
60ft...1.90
330ft...5.04
1/8....7.63 at 96.10mph
1000ft...9.82
1/4....11.70 at 122.42mph
-
07-21-2007, 03:00 PM #20
thats some good numbers
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
100hp Bolt-On Addition - The Buick 350 Turbo Kit
By Ed Blown Vert in forum General HelpReplies: 0Last Post: 06-01-2012, 05:00 PM -
Surging sensation in 3rd? HSW 100HP wet
By Eagle in forum NitrousReplies: 19Last Post: 05-02-2010, 04:28 PM -
Behold, 100hp!!!!
By smokiechicago1988 in forum Multimedia SectionReplies: 14Last Post: 11-23-2009, 04:33 PM -
Mopar B-Motor - 1,100HP Mopar - Engine Tech
By Ed Blown Vert in forum Almost Anything GoesReplies: 0Last Post: 02-24-2009, 09:00 PM -
What is the difference, besides the 100hp???
By KITT#42 in forum Firebird / WS6Replies: 8Last Post: 11-20-2006, 12:42 PM
Bookmarks