A question for all you tuners about new gears.....

[T's99BlackLs1]

I asked this is the drivtrain thread but I thought i'd put it up in here as well. In the next 2 months or so I am looking at getting the t-rex and 4.10 gears. Now I talked to the shop and they were talking about dnyo tuning as soon as it was finished. Now I thought this would be bad because of break in time w/ gears but he seemed to think if we just don't let them heat up it will be ok...Do u guys think he is right or me? He said we could do a street tune first if I wanted they dnyo it later but if it wont hurt anything I might as well do the dnyo asap. So any thoughts or exspeariances w/ dynoing brand new gears???

Thanks Guys.

[Bandit02]

Let them break in before hammering on them, at least give it a couple hundred miles to let stuff seat it. I'm assuming your using new bearings as well? More critical them, the gears almost "wear" in you could say.

[T's99BlackLs1]

And one other thing....I hear no long trips on new gears. Well what is considered a long trip? and for how long till that is ok? I mean I can't image that along w/ the 500 miles of soft driving you can't take it on long trips that whole time(or atleast I hope thats not the case!) Thanks everyone.

[MikeSomething]

And one other thing....I hear no long trips on new gears. Well what is considered a long trip? and for how long till that is ok? I mean I can't image that along w/ the 500 miles of soft driving you can't take it on long trips that whole time(or atleast I hope thats not the case!) Thanks everyone.

4.10's will make your car scream down the highway!!

[foff667]

4.10's will make your car scream down the highway!!

actually in an m6 they are quite mild...I know many that have gone with 4.30 & 4.56's and just a slightly larger tire when needed. In a daily driven car though 4.10's are about the optimal gear for most and you can actually use 6th gear