99Bandit
06-15-2008, 11:08 PM
I have to fix a Rear axle seal and replace a u-joint. So i figured while i was back there and had everything apart i would go ahead and replace a few minnor parts.
Ive been looking at the "Installation Kit, Ring and Pinion" from SLP. It comes with new pinion bearings, carrier bearings, crush collar, shim assortment, and seal. Is this a good kit too use, are there better out there?
Also for the u-joint ive been lookin at a couple on the summit site. Is there any prefered brand of u-joints or superior quality ones i should be putting in?
Ive been looking at the "Installation Kit, Ring and Pinion" from SLP. It comes with new pinion bearings, carrier bearings, crush collar, shim assortment, and seal. Is this a good kit too use, are there better out there?
Also for the u-joint ive been lookin at a couple on the summit site. Is there any prefered brand of u-joints or superior quality ones i should be putting in?