What Should It Run in the Quarter?

[xzaero0]

2000 Trans Am with a good Driver What should it be able to run in 1/8 and 1/4mile race?

A4
Ram Air
K&N
Cut out front Air Box
SLP Air Lid
Ported TB, and bypass
LS6 Intake
pushrods
American Racing Long Tubes Ceramic Coated
Off Road 3" Dual Exhaust with LM2s and X pipe
Mizierre electric water pump/ 180 deg. thermo
SLP Underdrive pulley
Moser 9" 3.70 gears Detroit Tru Track
UMI Subframe Connectors
UMI Strut Tower Brace
UMI Lower Control Arms amd Relocation Brackets
UMI Torque Arm and Relocation bracket
High volume fuel pump and wiring harness
3000 Stall

Weld 10x15 prostars with MT ET Streets
Tuned

[Y2KPewterSS]

12.3s or 12.4s

[2002 WS6 KILLS]

:drivin:^^^^Sounds right.

[nhraformula]

lower 12s

[INMY01TA]

You have all that done and haven't raced it yet?

[xzaero0]

You have all that done and haven't raced it yet?

No its not all done yet. I just got the intake today, the TB should be in tomorrow and the Stall is on order. Tune after everything is on. Havent ran with the wheels yet casue last time I was at the track I had the wrong lug nuts. :sillyme:

There is no 1/4 around here but there is a 1/8 but it has very little (if any) track prep.
With out The stall, intake, tb I ran on street tires at 8.7 @ 81mph. I lost .1 and 7mph due to lack of traction, Since new exhasut and rear end.

Thinking of going with a 100-150 shot too.

[INMY01TA]

Sounds like it's gonna haul ass. :bounce: