Cat'ed Y-pipe

[NetrixTardis]

I've been shopping around for a set of LT headers and a Catted y-pipe solution. So far the only ones of interest is the TSP-Catted y-pipe that will fit either Pacesetter and Kooks.

Anyone have had any clearance issues with this pipe? I am looking to also keep the rear O2 sensors. I did notice from pictures the TSP pipe doesn't seem to have a bung for them, Yet the kooks Catted Y-pipe does.

Also looking too see if the TSP vs Kooks Y-pipe bang up on the floor board (I am considering buying the bump stop clamp)

ps does the Kooks Y-pipe fit the Pacesetter LTs?

:help:

[nc2k2z28]

The cat on the drivers side is really close to the ground. I have mine adjusted very close to the floorboard, and I still can just barely put my fist between the cat and the ground.

There are no rear o2 fittings on the TSP catted Y, but you could have them added.