RPM q's?

[2000TA]

What does everyone shift there car at?
I have a ls1 with a 6spd. I usually shift at about 6,000

[majic]

I have LS1 A4 I shift @5200

[bad6as]

5800-5900 rpm's

[502ci]

At the track 5900-6000:Ohno: And on the street I lower the shift light to around 5500 to stay out of trouble:tired: This is with a six speed.

[MadSeason]

there's actually an equation to figure out the best shift point based off your transmission gear ratios, rear gears, and peak torque. For me I shift at, 5652, 5504, and 5410 with my slp 51013 cam and god damn i feel the torque throughout the whole 1/4mile

[Demonicbird00]

what times do you run? since your shifting there?

do you have a dyno chart of the cam in your car.

2000 TA....check out the thread next to this....."where to set my shift light at?"

me and madseason have a debate going on

[Hurley711]

5200-5300 rpms for me, that's where I kinda maxed hp wise out on my last dyno sheet so that's where I shift

[Demonicbird00]

btw i shift at 6k soon to be 6200 since i bumped the rev limiter up

[MadSeason]

what times do you run? since your shifting there?

do you have a dyno chart of the cam in your car.

2000 TA....check out the thread next to this....."where to set my shift light at?"

me and madseason have a debate going on

Currently running these times with my mods and street tires
11.57 @ 120 1.98 60'
11.44 @ 123 1.87 60'



Cam only was this on street tires shifting at 6800, since it pulls to 7200
14.1 @ 106 2.01 60'
14.01 @ 108 1.88 60'

When I adjusted my shifting after reading about optimal shift points on cam only I got

12.71 @ 115 1.90 60'
12.75 @ 116 1.85 60'

Check other thread for dyno of my car