SES light Question

[newguy WS6]

I have a 02 WS6. Have had it for about 2 months. I just removed the cats and gutted them and bought some O2 Simms. After gutting the cats I did not put the O2 Simms in right away.. The car ran fine for about 2 days then the SES light came on. I installed the O2 Simms Last night and drove it for about 15 minutes.. Drove it easy so the computer would have time to read the Simms. As of this morning I have driven it to work and the SES light is still on. Is there any thing I need to do to reset this or should I be looking elsewhere?

Any help would be appreciated
Thanks
Steve

[foff667]

it takes a few drive cycles for it to realize the rears are working ok...not sure of the exact number but it will take a "few"

[BIG D's SS]

There are 2 fuses that will reset the light pcm ign and pcm battery. Turn the switch on and pull these 2 fuses out for a few minutes. Then turn the switch off and reinstall them. When you crank the car again it will idle ruff till it relearns the system and it should be fine. Should have no problems.

[newguy WS6]

Thanks for the advise.. I will try it later on tonight and let you guys know the outcome.

Thanks
Steve

[newguy WS6]

Resetting the PCM seemed to work. Took it a few minutes to find Idle..seems to be running good now. Anything else I should be aware of? Im thinking about taking it back to the strip a gain before it gets too cold

Thanks for the help!

Steve