juiced99ws6
06-13-2007, 06:01 PM
So of course this is all theoretical but lets just say I just finished my heads cam swap and the other day my belt fell off driving down the road. There was nothing wrong with it so I just put it back on. I noticed earlier today that the belt was falling off the idler pulley so I slid it back on again to take it for a test drive since I removed and installed my intake manifold for a sensor problem. Anyways on the test drive the power steering went out again (after about a 1/4 mile) so I drove it home before the car heated up or lost power. Anyways right after the belt fell off I noticed that my idler pully fell off as it went flying out from the front of the car while I was slowing down. (I think that pulley could have done the 1/4 mile faster than a rice burner).
Ok now with the "theoretical" background information is there anything besides the actual pulley that I need to reinstalled everything properly. I have nothing there but the bracket and bolt hole so I am sure I will need a bolt but I think there was another piece, can anyone tell me what all I will need. Thanks in advance.
Ok now with the "theoretical" background information is there anything besides the actual pulley that I need to reinstalled everything properly. I have nothing there but the bracket and bolt hole so I am sure I will need a bolt but I think there was another piece, can anyone tell me what all I will need. Thanks in advance.