PDA

View Full Version : Placement of Jack Stands

rc74racer
05-07-2007, 10:05 AM
I'm wondering where other owners put jack stands when lifting their vert? It seems the k member is the best place to jack up the front but I'm not sure about stand placement.
Y2KPewterSS
05-07-2007, 09:41 PM
If you have SFCs on your vert, those work great for jacking and jackstands. :yup:
rc74racer
05-08-2007, 09:41 AM
Not yet but I figure sooner or later they will be a must.
Y2KPewterSS
05-08-2007, 03:22 PM
Not yet but I figure sooner or later they will be a must.

It was one of the best mods I did to my vert.
rc74racer
05-08-2007, 06:45 PM
What brand did you use?
Y2KPewterSS
05-08-2007, 06:46 PM
What brand did you use?

The BMR tubular weld-ins.
Silver Streak
05-08-2007, 07:04 PM
Thats what I had put in my ws6.. t-top... love 'em.
rc74racer
05-08-2007, 07:16 PM
Sounds good those were the ones I was looking at. I think after 410s those will be my next mod.
Y2KPewterSS
05-08-2007, 07:23 PM
Sounds good those were the ones I was looking at. I think after 410s those will be my next mod.

Good choice :yup:
JohnnyBs98WS6Rag
05-09-2007, 03:22 PM
Well, until you get your SFCs, jacking it where the owners manual recommends never hurts the car. Lift the rear w/ the diff, and lift the front at the K-member and slip the jacks in where the notches are under the rocker panel. If rotating tires, I jack under the axle and control arm using 2 jacks and lift one side, then the other.