LS1 in 69 Cutlass

[coolingpro]

I am about ready to buy a salvage 99 LS1/autotrans complete to put in my Cutlass. Would likely change the cam. And run an Eaton 3.73 limited slip. Any advice? I need a money tree.
Dave in Dallas
david@coolingpro.net

[mullenh]

where do you want to start? what have you researched so far?

[joerockhead]

My 67 Camaro has a 97 LT1 in it, with the T56.

The engine slipped in fine.
The Tranny was longer then the Powerglide I had, so a whole had to be cut for the shifter and mounts built to hold it on.
I also have a 3:73 rear gear and love it.
You are really going to like the clean look in your engine bay and the great power too!!!

[mullenh]

you have to cut and enlarge the tranny tunnel, but it is easy to do