problem with driving lamps

[linegtdt52]

Has any TA owner had an issue with excessive condensation build-up in their driving lamp assemblies? My bulb keeps blowing and I am getting sick and tired of one minute having a turn signal and the next being screwed! I think I am going to pull the light this weekend and reseal the lamp assembly and then go get a circle piece of foam from lowes and see if that fizes it.

[Redphoenix1998]

in heavy rain or rain in general they get water in them. When you replace your bulbs, make sure you load up the socket and the bulb connector with dielectric grease and you should be set. There are a couple of holes in the housing but it's to vent the heat because the DRL's are always on. Best advice, seal the hole and make a new one with a vent tube on the rear of the housing. A lot of owners have done this and they have no more issues

[linegtdt52]

Yeah I think I might do that.