PDA

View Full Version : my window is maxing grinding sounds!

quicky06
09-29-2005, 04:10 PM
as the title says when i try to roll down my driver side window it has a grinding noise..

it sounds like plastic gears at high speed.

any help would be apreciated

thank you
quicky06
09-30-2005, 07:01 AM
anyone?
BIG D's SS
09-30-2005, 07:36 AM
Try to grease the regulator and tracks and see if that helps.
02z28ls1
09-30-2005, 08:21 PM
Is it rolling down? If not then you're gonna have to take it apart and fix it-if you don't feel up to it then take it to a shop that can do it.It sounds like from what you're describing that either the plastic gear on the motor or on the cogged plastic "tape" that is connected to the window-or both- is stripped.Replacing the motor means drilling out some rivets after taking the door panel apart-if you're mechanically inclined give it a shot.If you're lucky the window itself is stuck and you can free it up and it will work fine.I'd at least take the door panel off and look.
quicky06
09-30-2005, 10:35 PM
no its not mooving . and there is no way i will take it to a shop and pay 400 to get it replaced. hell they want 250-300 to change my plugs
Silver2000WS6
10-01-2005, 08:58 AM
It is no to hard to change out the window motor. I have done mine. You can get a replacement motor for around $60 bucks. There are instructions on the internet.
02z28ls1
10-01-2005, 09:18 AM
Sooooo--tell everyone where to go on the internet for the instructions.(I don't know either-I've got a service manual)-It still sounds like the window itself is stuck-you ought to be able to shove it up and down if the motor gear is stripped. Take the door panel off and take a look-see if you can figure it out.It will be kinda tough to take the panel off with the window in the up position-but it can be done.
SeVeReDiStOrTiOn
10-01-2005, 12:18 PM
http://shbox.com/page/windowmotor.html
Silver2000WS6
10-01-2005, 05:03 PM
Was just gona post that. You beat me to it.Be careful if you try this.It is spring loaded. When you drill out the 3 rivets. It will unwind.Follow the web page. It is not that hard. good luck.
SeVeReDiStOrTiOn
10-01-2005, 09:26 PM
Was just gona post that. You beat me to it.Be careful if you try this.It is spring loaded. When you drill out the 3 rivets. It will unwind.Follow the web page. It is not that hard. good luck.

:firedevil