BitViper
12-26-2006, 08:23 AM
Ok...
I just installed my TA Diff. Cover and emptied 3 quarts into the thing...and it never spilled out.
Most guides say it will only take 2 and bit..now the car WAS up on stands, nose down.... could I have over filled
If so, is the only draw back will be some weeping from the over fill..correct?
next I got this
If you run it with too much fluid, you run the risk of blowing out your axle seals.
And I have this question.....
..why would the seals blow out if there's a vent plug at the top of the housing.
Why w/n the fluid expand into that void then out the vent? Why would the system get that pressurized..I could see how the system might ove-pressurize if the housing was completely full and it experienced a momentary increase in pressure while trying to get fluid out the overfill
Educate me
I just installed my TA Diff. Cover and emptied 3 quarts into the thing...and it never spilled out.
Most guides say it will only take 2 and bit..now the car WAS up on stands, nose down.... could I have over filled
If so, is the only draw back will be some weeping from the over fill..correct?
next I got this
If you run it with too much fluid, you run the risk of blowing out your axle seals.
And I have this question.....
..why would the seals blow out if there's a vent plug at the top of the housing.
Why w/n the fluid expand into that void then out the vent? Why would the system get that pressurized..I could see how the system might ove-pressurize if the housing was completely full and it experienced a momentary increase in pressure while trying to get fluid out the overfill
Educate me