Clutch Stage 3

[LS1camaro_29]

Anyone know why the stage 3 spec clutch kit has to take 3to400 miles to break in? It suck driving it right now. The car jumps up and down at every light unless you launch hard.Spec says the jumping will go away after break in. I just hope every bolt in the car stays tight. LOL

http://gmhightechperformance.com/features/0401htp_extreme01_z.jpg

Car: 2000 Trans Am
Owner Joey Rosario
Stock LS1
Throttle body: Stock, ported
Fuel injectors: Vortech 38 lb./hr.
Fuel pump: Vortech T-Rex
Ignition: Stock coil on plug
Engine management: Stock PCM tuned by Morgan Motorsports
Power adder: Vortech V9
Boost: 9 psi
Intercooler: Air to water aftercooler
Exhaust system: Custom Y-pipe and Dynomax Race Magnum muffler
Transmission: Stock T-56
Clutch: Spec stage 3
Driveshaft: Aluminum
Front suspension: Eibach springs, Hotchkis 35mm swaybar
Rear suspension: Eibach springs, Hotchkis 25mm swaybar, control arms, LG Motorsports torque arm
Rear end: Stock 3.42 gears with Torsen limited slip
Brakes: Stock with KVR drilled rotors
Wheels: Racing Hart M5 18x10
Front tires: BFG 265/35/18
Rear tires: BFG 295/35/18
Best ET/mph: 11.61 at 121 mph
Best 60-ft. time: 1.75

[rajiv1998]

yeah it blows for the first 500 miles. I got one done last year and it was impossible to drive. I actually stalled it a few times. We took it back and the guy said to wait 500 miles and it will get back to usuall. I dont know if its the SPEC in perticaular or if all the other clutches do it??

[third_shift|studios]

that car needs a face lift...

i have a spec 3. It took about 2000 miles for me to get used to it. now i can slip it and drive however i want to.

[Mr. Luos]

SPEC sprung clutches require a break in period of about 500 miles.
Although I have heard it take more like 3000 miles to get them to loosen up all the way.

I personally run a SPEC stage 5. No break in, and it will not slip. Ever. :lol:

[s99ta]

my spec stage 3 was the same way, like you never had drove a stick before. now its OK works good 5grand launches