Do I need a new slave cylinder???

[slo4mula]

I just did the drill mod and installed a new Master cylinder. I bench bled and installed the new master and it worked for 2 days. Today, the pedal once again lost all pressure. When I hook up the mityvac to the master reservoir it will not hold any pressure. I have tried traditional bleeding and no matter how much I pump the pedal, no pressure will build up.

Am I correct in saying the since the mityvac won't hold any pressure that there is a leak in my hydraulics???? I really wish this wasn't my daily driver....

[slo4mula]

So, I am replacing the slave cylinder and all was going well. I have the driveshaft out, the torque arm off, all sensors disconnected from the tranny. I have 6 of the 8 bolts out of the gearbox. HOW THE HELL DO I GET THE TOP 2 BOLTS!!!!! I've tried lowering the transmission as much as I can, I just can't get to them. Please help me!!! I have to finish this tomorrow at 1pm.

Any help is very much appreciated.

[RMC]

If I am reading this correctly, you are asking how to get the top bolts on the transmission. Its been a year or so but I will tell you what I can. You need about two feet in extensions. You will use the ratchet all the way down on the other end of the trans. I had a partner that would make sure the socket was on the bolt and then when it was secure I would start turning. You may need a swivel right before the socket. There are several posts about this if you look hard. But trust me, you need a couple feet of extensions and a helper would be a huge advantage.

[bealschad]

Are you unbolting it were the bell housing meets the motor??????

[slo4mula]

sweet!! I just read that somewhere else also. Unfortunately it is dark and now its a job for.... "TOMORROW MAN!!!...sorry...

Everything was going really well, which naturally made me nervous. There was no way I was going to get this job done in a reasonable time frame.

Maybe I should do an oil change as long as the car is in the air:hmm: I haven't screwed an oil change up ever.

[slo4mula]

Are you unbolting it were the bell housing meets the motor??????

nope. I'm unbolting it where the gearbox meets the bellhousing.

[bealschad]

Ok I just did a tranny swap from auto to 6speed and i had to learn it the hard way so ya anyways from the gear box is the only way to do it ezey. Good luck with the slave thay are a son of a bitch to plug back in be patient it took me 30 min.

[slo4mula]

So, I got all 8 bolts out of the transmission. Every write up says that the transmission should "slide backward without too much fuss." Is this total bullshit or am I just incredibly unlucky? This is one of the worst projects I have ever taken on, AND I'M ONLY REPLACING THE SLAVE, not the clutch. This sucks. Anyone else have problems getting the gearbox off the bellhousing??

[ss~zoso~ss]

lmao the thread was called "do i need a new slave..." on the main page, couldnt help but laugh