PDA

View Full Version : Got my cam installed

BlackBeastLS1
08-18-2006, 04:13 PM
The numbers seem really low to me the chart says I only got 339rwhp, but that doesnt seem right to me.
440 rwhp trans am
08-18-2006, 04:14 PM
what type of cam is it? what other mods
BlackBeastLS1
08-18-2006, 04:28 PM
Comp cam 232/236 I got k&n fipk, catback, and shorties. they said the shorties were really restricting and that if i got LT's and an ORY then id be at about 390 to 400.
440 rwhp trans am
08-18-2006, 04:34 PM
yeah no go with shortys on a 98-up lt's are your only choise. not much lift. 236? isnt that right above stock? idk. i have 564 lift and my cam is not that big
440 rwhp trans am
08-18-2006, 04:37 PM
the cam only gave you 29 hp over stock and you do have headers. im confused??? is the 329 on a dyno
BlackBeastLS1
08-18-2006, 04:47 PM
no the lift is 0.600
440 rwhp trans am
08-18-2006, 04:49 PM
you should of picked up more gain than that unless the guy lied to you about what he put in
BlackBeastLS1
08-18-2006, 04:52 PM
I know they didnt because me and my dad installed it they just tuned it.
440 rwhp trans am
08-18-2006, 04:56 PM
i have no clue what your problem is but i think you do have one
nhraformula
08-19-2006, 06:49 AM
get rid of the shortys and converter and you will gain atleast 40 rwhp.
The Rookie
08-19-2006, 06:56 AM
Yes you definitely need long tubes!
ninobrn99
08-20-2006, 03:18 PM
a few things:
the shorties for one have to go!
you already have a ls6 intake so thats good.
did your dad install the cam correctly? did the dots line up? i agree with everyone else here though. that cam is WAY!!!! too big for shorties. Once you get better exhaust flow, you'll see a much better gain.
bene
08-20-2006, 03:40 PM
Who tuned it? That's still low for cammed w/ headers. 01-02s usual stock dyno is around 315-320 rwhp. With catback/lid/headers you should be around 320-330rwhp. So at the most you only gained 9 rwhp with a tune?
BlackBeastLS1
08-20-2006, 05:19 PM
RPM in dallas tuned it and yea it was installed right and everything. I dont know what I should get next long tubes or a converter though. They said if I switched to Lt's then I should see around 390 to 400rwhp.
ninobrn99
08-20-2006, 05:39 PM
either way, you're going to need both. you shouldnt have put that cam in there before you did your exhuast. the reversion on that cam is too much for the stock exhuast manifolds.
SSwt00SS
08-22-2006, 01:31 PM
RPM in dallas tuned it and yea it was installed right and everything. I dont know what I should get next long tubes or a converter though. They said if I switched to Lt's then I should see around 390 to 400rwhp.

RPM here in Dallas tuned your car? They installed my cam, retainers, springs, etc and then tuned my car and I gained 25 rwhp and 14rwtq and I only have a 224 cam, stock intake and stock manifolds w/cats. your cam results should be higher since you had a bigger cam installed. Those boys do good work. did you upgrade the springs, retainers, bases, pushrods, etc? It's not adding up? like nino asked, did you install the cam correctly? Where you there for the tune ( i was there for mine)? What about a dyno result sheet with A/F rations, etc.?
nc98z
08-23-2006, 09:39 AM
Are you running an A4 or a 6-speed. If an A4, what kind of stall are you running?
unnatural aspirations
08-23-2006, 12:59 PM
my 2002 z28 made 380 rwhp with,kooks lts & ory,ls6 intake,ported maf t/b free mods,k&n cold air,ud pulley,royal purple oils,tune...i just put in the ms3 and precision race components valvetrain stuff, so with a cut out im expecting well over 400 rwhp.but runs like shit without a re tune..and BRO THE SHORTIES GOTTA GO,THATS LIKE BUYING AN UGLY HOOKER,SURE IT WORKS BUT NOT WHAT YOU REALLY WANTED
unnatural aspirations
08-23-2006, 01:02 PM
Bene Lt's,lid And Full Exhaust Will Net You More Than 15rwhp.especially On A Tune