good or noand what now...

[pyrows666]

so i have and 89 formula firebird...

5.0 tbi 700r4



anyways.

Umi pan hard bar and control arms INSTALLED

KYB AGX - INSTALLED ( oh yeah upon installing front left (driver side) torqing down the bolt on the strut tower top where the dial is 1-4... dial came off in the socket.. didnt look damaged but i cliped it back in it had a grove to see where it went.. but out of the package there were set on 2 now scince that dial came out i dont know if i should worry about what setting its on.. but then again it came out... any ideas..


hotchkis sub frame connectors going in TODAY

relocation brackets going iN TODAY( I LOST THE BOLTS AND STUFF FOR THE BRACKETS.. IS THERE SOMTHING I CAN GET FROM OSH (ORCHARD SUPPLY HARDWARE? ) BOLT SIZES ANYONE AND SPACERS???

LET ME KNOW PLEASE...

THANKS JEFF

[ferocity]

I like relocation brackets, i noticed a little improvment. But if you put them on the last hole as i did then when you try and peel out in reverse you are going to get a lot of wheel hoop, so don't panic as i did, its wheel hop cause by useing the lowest hold on the relocation bracket.