SLP Diablosport Question

[LS1FBodyZ28]

Is there anyway that this tuner can delete codes. I bought qtp long tubes and a catted y pipe and i had the tuner set to no o2 codes setting and my cat broke apart on the driver side. So i think that the no o2's setting it was on was making the computer think that there were no o2's at all and causeing the car to run rich or lean. I then put a new cat and i put the regular slp tune on the car and the ses light came on for no rear o2 sensor activity. I am wondering if i can delete the codes off the computer so the ses light stays out.

[silverTA2002]

Yes it deletes codes.

You only want to delete the REAR o2 codes. You need the front o2 sensors.

If COT (cat overtemp protection) is off, and you still have cats, you may destroy the cats. It adds fuel to keep the cats from dying.

[LS1FBodyZ28]

I do have cats. I am not sure If COT is on or off. I will make sure that is on but how do u delete the reaer o2 codes?

[silverTA2002]

I do have cats. I am not sure If COT is on or off. I will make sure that is on but how do u delete the reaer o2 codes?

I'm pretty sure it's in the manual as far as HOW to delete the codes.

As far as "which codes" to delete....

Anything that says, "Bank 1, sensor 2" or "Bank 2, sensor 2."

DO NOT touch any code that says "sensor 1."

[oneBADDz]

Just wait till the SES light comes on to tell you of no activity on the rears, then delete the codes that popped up. I couldn't remember then numbers, so I just did it like that