Turn Signal not working

[ak1]

The left turn signal works fine. When operating the right turn signal, the rear ligts up solid, no blinking and the front does not light up at all. The dash indicator is lit up solid not blinking as well. Replacing the bulbs did not fix the issue. When operating the hazards, the dash blinks and the rear blinks but not the front.....Any experience with this issue or similar issues will be appreciated.
Thanks again,
ak1

[Fade2Black]

Yeah, I just fixed that problem today. Did you hit a puddle of water? I had to take the old bulbs out, clean the area you insert the bulb, dry it with a blow gun, and use dielectric grease to block water from getting in again. You put the grase all around the part of the bulb you insert into the little slot, mainly on the two white lines that are on each side. Use a lot of it thought when you put the bulb back into the socket it will push out any extra. The socket for my bulb had rust in it from the water so I had to clean it. If you need to clean yours you can use water and a brush of some sort. I used water and sand paper because I didn't have much to work with.

[ak1]

Thanks, I'll give that a shot this weekend.