--HELP-- wiring system (passing wire from inside into door)

[Eugenio_SS]

I've seached with no results :(

in the midst of finalising my stereo install... tests are good, and want to pass the wires from the splitters to the front speakers and tweaters.
That means I have to pass wires through the little wire gourmet that goes to the door.
Access seems like hell.
Anyone done it ?
Any pointers ?
Especially from the inside of the car area, close to the fuse box... how can i pass wires from inside the car to the door ?

Thanks for help

[White Rascal]

I use a wire clothes hanger with the wires taped to the end. I start by feeding it in thru the door into the rubber boot. I use my free hand to help guide the hanger thru the boot. Once it's thru the boot and into the kick panel area the rest is easy.

[sgt0704]

I use a wire clothes hanger with the wires taped to the end. I start by feeding it in thru the door into the rubber boot. I use my free hand to help guide the hanger thru the boot. Once it's thru the boot and into the kick panel area the rest is easy.

:iagree:

[Eugenio_SS]

i'll try it from the door towards the inside, hoping i can feel it on the inside and play with it.
Thanks ;)

[Walking-Dead]

That's the way I did it but I happened to have an electricians fish tape. Same thing as a coat hanger. Its is a PIA though!! Especially on the drivers side cause the harness is a little larger going through there as I recall. Use quality cable so you don't have to do it again ever.

[mikeaford]

agree I have a home flat wire puller I spooled out and fed through there wrapped the wire in tape and pulled it back through agree - this is a PITA or lower back...