rick67
09-09-2009, 01:39 PM
So I'm getting ready to install meth injection, boost controller, and A/F gauge into my car and get it tuned. My parts will start arriving tomorrow.
(STS turbo car, 5PSI, all stock except injectors and 3600 stall)
My best pass so far was 12.41 and I'm trapping around 5,500 RPMS in 3rd gear.
I would hope by adding meth and cranking my boost up to 8-9 PSI I should easily be in the 11's. (not sure what my trap speed will be after adding the extra boost)
I'm considering swapping rear ends from the factory 2.73's to a 3.42 rear end I found as well.
My question.... Simple math tells me that 3.42's are about 25% steeper than 2.73's. So 5,500 RPM at the traps would now be almost 6,900 RPM assuming my MPH stays the same.
I don't want to trap that high! Can I shift into OD at the top of the track under WOT? Or should I just keep my 2.73's?
Thanks in advance for your insight! :)
(STS turbo car, 5PSI, all stock except injectors and 3600 stall)
My best pass so far was 12.41 and I'm trapping around 5,500 RPMS in 3rd gear.
I would hope by adding meth and cranking my boost up to 8-9 PSI I should easily be in the 11's. (not sure what my trap speed will be after adding the extra boost)
I'm considering swapping rear ends from the factory 2.73's to a 3.42 rear end I found as well.
My question.... Simple math tells me that 3.42's are about 25% steeper than 2.73's. So 5,500 RPM at the traps would now be almost 6,900 RPM assuming my MPH stays the same.
I don't want to trap that high! Can I shift into OD at the top of the track under WOT? Or should I just keep my 2.73's?
Thanks in advance for your insight! :)