Lowering Springs

[ntymd8r]

What springs to get????? I'm looking for something not bouncy, obviously, eliminates the wheel gap and performs good....what's the brand I would be happy with? Eibach Pro-kit, BMR or G2?

[TwistedSS]

I hear the rear springs for eibach sag after a few months...but idk

[SSNAKEATER23]

eibach pro kit is the way to go. it only drops the car about 1.2 all around. The sportline kit drops it 1.5, and its way too low.

[ntymd8r]

Cool...the pro-kit is what a bought. I also bought the bilsteins...they'll fit these springs with no probs, right?

[SSNAKEATER23]

Yah you should be ok, with all the components you got. Good job on doing springs and shocks at once it will save time and money doing it all at once. :shots:

[BIG D's SS]

I went with Eibach springs and KYB AGX's. I'm all about doing both at one time.

[ntymd8r]

Thanks for the positive posts! I'm also doing the BMR STB, Adj PHB and bolt-in control arm reloc brackets...by the way, anyone know which hole to put the control arm in?...the top or bottm?

[BIG D's SS]

Thanks for the positive posts! I'm also doing the BMR STB, Adj PHB and bolt-in control arm reloc brackets...by the way, anyone know which hole to put the control arm in?...the top or bottm?

I bought a set of weld in, but it said for a lowered vehicle to put them in the bottom hole. The flatter the better.

[ntymd8r]

Thanks Bro!:thumbup: All your guys help is much appreciated...can't wait to do the install this weekend!

[BIG D's SS]

I need to get mine installed. I have been trying to do 3or 4 things at a time. Need to concentrate on one at at time.

[ntymd8r]

Good luck with you install...

[third_shift|studios]

dayum...i wish i was like this dude-ask a question, go with the first response, and hope all runs well :lol:

I've been debating on certain combos for about 2 months now....and still aint' bought shit.

[ntymd8r]

Nahhh...did my research and I'm going with my gut...I've been in a Z with the same setup a couple months ago and it felt good...just seeing if anyone else was trying something with a different setup...