ls1 cam tool

[z28comaro]

Where do i find the two rods that I can buy to hold the lifters up while pulling the cam?

[666ws6]

I can find out where I got mine a few years back. If you don't get any response by Friday, PM me. I'll be home this weekend to check where I purchased them.

[thearborbarber]

http://thunderracing.com/catalog/?action=vshop&vid=3&pcid=17

[666ws6]

That is prolly where I got mine, now that I saw the link.

[Hi-Po]

Good luck getting that tool from TR anytime soon. I have heard weeks in delays. Maybe its changed. But why, why would you spend that much money for a tool your gonna use for maybe, maybe 10 minutes why you swap out the cam.

Go to home depot and buy to 5/16 wooden dowel rods and cut them to length you need. Some people are afraid to use a wood product inside thier engine. Your not forcing anything in there. Not like your going to pound these wooden dowels in with a 4 lb hammer. They slide in and slide out very easy and will cost you under 5 bucks.

[JoshieDoom]

use two wooden dowels....

[67rsss]

Unless you plan on building a lot of cam only cars, just buy the wooden dowels, or even pick up a piece of rod and make them yourself. SHould have less than $8 invested.

[20ws6speed01]

they don't use rods on T.V.

[JoshieDoom]

they don't use rods on T.V.

If you have the original first ls1 cam episode on HPTV, some get dropped and doesnt stay inside the trays... and the suggest it...

[mrr23]

home depot 5/16" wooden dowel rods. about $1.16

[stephen02ws6]

i used 5/16 brake line that i flattened some

[Hi-Po]

home depot 5/16" wooden dowel rods. about $1.16

Damn, Priced down to the penny. :)

[20ws6speed01]

this is an LS3 motor? ON HPTV?

[mrr23]

Damn, Priced down to the penny. :)

well, it's been about two years since i bought it. might have gone up.

[Hi-Po]

well, it's been about two years since i bought it. might have gone up.

I think mine was..... 2.36 :toetap:

Ive been ripped off!

[mrr23]

florida is cheaper haha!!