where can i get a 9''

[bmwmteam]

i'm looking for a full rear end not just the housing do any manufactures make a full setup i already tried mosher and currie.

[Jays00ss]

Quick Performance Racing. Its a store on ebay. Thats where I got mine. Cheapest you'll find, Build it up YOUR way, great customer service, and on my front doorstep 5 days after ordering. Gears were set nice a quiet, no issues with mine at all with just over 6000 miles on it and a few nights at the track.

[bmwmteam]

mind if i ask how much

[Jays00ss]

I got mine built to the max. Moser housing and 35 spline axles. New reluctor rings installed, drain plug, extra long 5/8" wheel studs, Strange Pro Nodular third member with billet yoke, Motive performance 4.30 gears, Eaton Detroit Locker, timken bearings. Mine was $2350 Shipped.


You can get a basic set up for about $1850-1900 through them (Standard third member, 31 spline axles, basic posi unit, no reluctor rings, no drain plug, cheaper bearings)

[konigandy6]

I totally went into some parking lot and cut it out of another Fbody... so mine was free!!!

No but for real... Exotic performance is where I got mine, they seem to be a tad more pricey than where Jay got his, but the guy knew is stuff and even helped with technical questions I had during install.

$2900 to my door.

[Zboner]

I totally went into some parking lot and cut it out of another Fbody... so mine was free!!!

No but for real... Exotic performance is where I got mine, they seem to be a tad more pricey than where Jay got his, but the guy knew is stuff and even helped with technical questions I had during install.

$2900 to my door.


ouch, i also got mine from exotic performance plus great guy, mine was 2,200 at my door

[konigandy6]

ouch, i also got mine from exotic performance plus great guy, mine was 2,200 at my door

I opted for the aluminum center section, powder coating, and the drain and fill plugs....

[Hi-Po]

ouch, i also got mine from exotic performance plus great guy, mine was 2,200 at my door

I opted for the aluminum center section, powder coating, and the drain and fill plugs....

This, I want to know. I am seeing 2500 shipped. No drain plugs and nothing else optioned. Ive heard 2200 and 2400. You didnt go with tru trac thou did you Boner?

[Zboner]

This, I want to know. I am seeing 2500 shipped. No drain plugs and nothing else optioned. Ive heard 2200 and 2400. You didnt go with tru trac thou did you Boner?


nope alum center section 35 spline's and a full spool, im hardcore.

oh and fuck the powder coating, lol it was like what 180? a can of rustolem went a long way it has been 2 years no rust and if there is hit it up again

[Hi-Po]

nope alum center section 35 spline's and a full spool, im hardcore.

oh and fuck the powder coating, lol it was like what 180? a can of rustolem went a long way it has been 2 years no rust and if there is hit it up again

How thats on a street car?

[Zboner]

How thats on a street car?

really you will never notice it, unless your making a very hard turn at very low speeds.

[Hi-Po]

How many street miles you drive it yearly? I only know of a handful of people that dont have the tru trac here. You and Jays02ss. Im buying a 9" Monday, have to make sure I order it with everything I want/need.

[Zboner]

How many street miles you drive it yearly? I only know of a handful of people that dont have the tru trac here. You and Jays02ss. Im buying a 9" Monday, have to make sure I order it with everything I want/need.


prolly under 3k this year on it no more, I wont drive it to work (very bad area) and i only will drive it friday-sundays with no rain of course, because what is the point of driving with the top up

[Hi-Po]

I think I will stick with a tru trac. :)

[Qwk Vet]

True Trac is good stuff for a nine inch!

[konigandy6]

True Trac is good stuff for a nine inch!

+1!!! Very quiet and streetable!