Replaced shift solenoids still having problems

[99Z]

Ok I replaced both of my shift solenoids last night because I kept getting an error code that said b solenoid stuck open. Today its throwing the same code, could this be a wiring harness problem or a bad connection.

[SDB]

try clearing the code again...I went through this before...

SDB

[99Z]

I had the code cleared and its still doing it.

[mrr23]

what converter do you have?

[Terrance]

Where are our shift solenoids located

[mrr23]

on the rear of the valvebody located inside the pan.

[TTS]

Check the battery voltage @ the transmission fuse. Must be over 12.5 and must be over 8.5 when cranking. If not, replace the ignition switch. The next one will cost ya.;)