- Push Rod Length for 383 Stroker...Help!!
- What do you think
- Rocker Arm Replacement
- Out with the old in with the new
- Rockers
- Can you pass emissions w/Trex?
- 1998 Z28 Knock Sensor
- cam/rocker combinations?
- Cam/springs??
- Patriot cam 226/226
- Need your help
- most of my valve springs are broken
- Needles in pan...
- Head R&R
- How do I get taller install height?
- Bottom end build
- lq9 6.0l block
- Taking out motor to swap cam?
- check this out...short vid of my car
- 382 Stroker Basics?
- Ls6 Cam Question?
- Carbon build up?
- Yella terra Rocker installation ?'s
- Texas Speed 233/239 Cam?
- LS1 no cats emission results?
- heads?
- PRC or patriot gold?
- Added Horses
- virgin huggar z
- WHat cam should I go with?
- timing Chain
- Port and Polish GM LS6 Heads
- hotcam
- stock connecting rod lenght?
- Metallic Clicking Noise when Changing Gears
- Patriot cam installed - my thoughts
- Found a tuner, cheap too
- afr slp heads
- bad ticking noise
- How hard is it to spin a main bearing?
- Are these really reliable engines?
- Getting to 408 CID
- Engine Readings
- GM's LSX Engine
- Does anyone know how much valve lift a stock LS1 engine can handle?
- head swap
- Out of curiosity - NASCAR parts
- cracked block
- CID and HP
- Anti-freeze
- Which Cam?
- Motor Swap
- any advice???????????
- remove eng from the top?
- should i use the cam from my old engine?
- 500WHP cam/head setup?
- Anyone Do Cam Installation In Reading PA??
- Lq9 - 427?
- 6.0L engine 317 or 241 heads
- Ls1 Cam Swap
- Head swap concerns and questions
- Oil Filter
- Worn out stock LS1 rockers?
- Cold Engine Noise
- ls1 to ls6
- need heads and cam advice
- TSP 228R or 224 XE (spring life and LSA ?s)
- Piston Size ????
- mild cam horsepower?
- Need Cam Advice
- 7.0l
- Dead Engine.. 2006 Civic SI
- Bent Pushrods
- camshaft question, need help
- Looking For Cam Advice
- shaft mounted LS7 rockers
- cam
- Driveability after cam???
- Old Timer 50's and 60's Philosophy
- Newbie needs advice.....H/C Package..
- N Motion Timing set PN 7140
- need crankshaft help quick
- help picking out a block
- Your Opinion on a 416 Stoker with L98 Heads
- COMP CAMS Grind # LS1-3720R-3669R HR119.5
- cams and mileage?
- L92 HEADS l76 intake on LS1?
- cam question...
- Need help with decisions on rebuilding ls1
- 6.0 Swap - NEED HELP ASAP!!!!
- when installin a cam......
- A Question For All You T-rex Owners
- rocker arms?
- What kind of oil do you run???
- Oversized Oil filter for 02 SS Camaro ?
- Mti R1 Cam
- Rocker Arms
- Head/cam package from Texas Speed
- good cam for 94/z28
- ZL402 from SLP ?