- Best price on twin disk?
- Do i need adj. LCA's?
- '01 SS Won't Go Into 2nd Gear!
- Recommend me a clutch!
- clutch setup?
- Look No Further For A Shift Boot Clip
- Centerforce I Disk or Dual Friction?
- Repair shops in Jacksonville, Florida
- Tranny is going out! Severe whine above 45 mph!
- Is It Bad To Get An Aluminum Flywheel?
- Transmission locked in 4th gear.
- Installing 4:10's - Easy or Hard?
- What is that mod that you MUST do to make it so you can spin the wheels going 2 2nd
- Mcleod Slave mod.
- OKAY...slave or master??
- swap
- Fly Wheel ?
- clutch and tranny problems
- what is the torque lbs for the M6 tranny mount?
- Grinding noise
- Mc Leod clutch rebuilt/ aluminum flywheel
- Clutch Problem
- Whats the Torque Capacity on a stock LS1 clutch???
- a slight concern
- master and slave cylinders?
- somethings out of balance!
- clutch installation ??? $$$$$$
- Mid engine project, transaxle needed
- squeaking noise in clutch pedal
- Drill Mod necessary or can I just by the 01-02 part
- Need HELP!! Manual 5speed to LS1 M6 Tranny Swap
- umi short shifter handle installed.
- minimum flywheel thickness?!!!
- extreme shaking
- Clutch pedal assembly question
- Clutch Questionnn!!!!11????????
- T-56 torque rating?
- removing the clutch master cylinder
- Please try and tell me what I broke
- Grind when shift into third
- How much fluid
- McLeod dual disc aluminum flywheel
- LS7 clutch
- i need some help
- Is the 02 WS6 Colletors Edition Rear different then the rest???
- Tranny problems, need advice
- Can't get it into fifth half the time!
- 2nd gear lockout
- need help
- What shifter is this?
- LS7 clutch install
- Shifter?
- Zo6 clutch
- Adjustable Master Cylinder
- Accident F*ed up my tranny HELP!
- flywheel chatter?
- How long should it take to install new clutch/flywheel?
- Transmission doesnt shift into third under hard accel.
- What are the symptoms of syncros going out?
- 1998 6-speed how do i bleed the clutch?!
- Clutch pedal sticks and gears grind sometimes... Help!
- Automatic to 6 spd, need help
- need help selecting a shifter
- Changing transmission fluid in the 6 speed?
- clutch suggestions?
- Sync Going Bad?
- Which clutch?
- Difference in T-56's
- Ripper Shifter/Pro 5.0/or Just Do A Short Stick?
- Ripper Shifter/Pro 5.0/or Just Do A Short Stick?
- Master/Slave
- weird grinding
- will a 93 t56 tranny fit in a 99?
- Ugh
- Swap From manual to auto
- install university link down need help
- Shift point question with 4.10s
- Slave Swap Question
- Transmission Rebuild Question
- WTF....why is my clutch pedal not operating.
- Clutch Stuck To The Floor???
- Breaking in a clutch
- Anybody installed one of these?
- Need good t-56 tranny rebuilder
- Drove M6 1 QT low on transmission fluid, any serious damage?
- funky clutch feel
- hydraulic install question
- 2002 Camaro with a hurst
- 5-6 synchro?
- Clutch problem..help please
- Clutch!! Stuck
- shifting sloopy at times and notchy
- Need a new clutch.
- Grindind gears at Redline
- Short throw ?
- LS7 clutch problems
- Stiff clutch
- Torque for flywheel bolts?
- Loose HURST SHAFT! HELP
- Trans upgrade Spec & Fidanza