- Another Maf Question
- Can you drive in the rain with an slp lid?
- Maf question
- Big problem after header install.
- Questions about headers and Y pipes...
- Edelbrock Long Tubes
- Power Chip & washer airbox mod Question...
- Header installation
- Power Boost - Exhaust for stock SS
- new headers aint workin for me....
- Water in intake
- Pacesetter Fitment Questions
- service engine light
- Tune for LT Headers
- Can I tune out codes to pass emissions?
- Armor Coated Pacesetter LT's
- borla
- want slp loud mouth muff have edelbrock can i just switch mufflers?
- Whats that catback exhaust system
- Borla or Maga Flow
- TSP ORY vs Pacesetter ORY
- LM1 Exhaust question
- Need 97-99 Factory headers from Corvette
- Should i get aftermarket header gaskets & extensions?
- TSP ORY vs. Pacesetter
- Ls 6 Intake?!?!?!?
- Cheap O2 Sims
- Need Help
- Lts
- LS6 Manifold Question.
- Ported throttle body/ bump stop mod
- Maf Problem???
- what size bellow to get if getting one made?
- Professional products throttle body
- O2 simulators?
- Help: Where can I get a Camaro SS 3" Intermediate Pipe?
- Ls6 intake
- after header install
- true dual question
- Pacesetters LT
- Open exhaust?
- rwhp estimate?
- AIR Pump and ORY
- slp lid
- Exhaust Cut Out?
- Intake install
- crush bends vs. mandrel bends
- Trouble codes need help
- Cheap way out
- Plug Wire Removal
- oil filter
- Spark plug install tricks needed
- Question about rockers?
- installing headers
- installing intake right now?????`
- LT1 intake upgrade???
- What length exhaust tips to go with?
- Electrical Exhaust Cutout or Loudmouth???
- Best Exhaust for '00 SS
- question about manifold????
- Belefits of removing AIR and EGR?
- A big brown truck came to my house today...
- Backpressure opinions!?!
- Can't stand this exhaust rattle
- Header and Y pipe help
- knock sensor
- Best Exhaust System for 01 SS?
- buy new TB or send out stocker to get ported?
- Pipe between manifolds and y-pipe?
- Are stainless headers better than ceramic?
- throttle body question
- QTP Headers w/ Pacesetter Y-pipe
- SLP lid question
- Radiator flushing.....
- what do you think about borla with my setup
- Check Gauges/LS6 Intake Install?
- Which plugs to get
- Slp Lm 2
- Video of my car w/ Pacesetter LT's, ORY and LM2
- 1 chambers vs. bullets
- Cat back crap attack.
- coolant bypass???
- how much quieter will it be?
- valve cover question *help*
- o2 solenoid oxygen sensor
- Fuel Injectors
- Low temp thermostat
- Kooks headers and ypipe
- Horrible Discovery!!
- Where to buy stainless headers
- stupid question
- Mac Catback vs. SLP LM
- What CAI kit do you own? (SLP, FTRA, SSRA)
- Think I need cats; what are the best ones out there??
- is PVC catch can even worth to do? pro/ cons
- exhaust cut outs
- TR55 or TR6
- what is the best exhaust
- which headers have good clearance?
- 46,587 miles stalling out